Close
Free Pair of SWAROVSKI ELEMENTS 12mm Butterfly Beads with Swarovski Crystal Purchase
Beading Instructions

Beading Resources > Free Beading Instructions > > Memory Wire Bracelet

 Memory Wire Bracelet 

by Judy from Fire Mountain Gems and Beads
4B10
Have you tried Memory Wire yet? Memory Wire has 12 continuous loops and comes in sizes that can be used to create a necklace, bracelet or a ring. It is steel and is very strong. It will hold its shape and conform to your arm or neck. This great design is just the beginning of what you can do with Memory Wire.




We're sorry, your browser does not have the necessary Flash player installed to view the content you selected.

Get Adobe Flash Player
click hereto install the latest Flash Player.
**Before installation, please close all other open browser windows.
: : : Materials : : :
End of Materials List
Step 1
Determine the number of loops you want to use for your project and cut the wire. 6 loops were used for the bracelet.
Step 2
Stretch the wire gently until it is comfortable on your arm and a little easier to work with. This does not mean stretch to finished size. It can be formed after you finish. That is why memory wire is used so much for gifts and pieces you sell, there is no need to know the size.
Step 3
Determine if you will have a center motif (you would begin the design by taping off the other side and creating a pattern that would be mirrored on the other side. Or simply lay out the design on the board.
Step 4
Before adding the beads, bend a loop on one end by taking your round-nose pliers and bending the loop toward you (not closing it completely)
Step 5
Add beads--just like stringing but with no needle. Add beads in the following order and repeat the pattern to the desired length. (See materials list for bead descriptions) #1, #2, #3, #2, #1, #4, #3, #4.
Step 6
Add a loop on the other end, tightening up the beads to hold in place.
Step 7
Add a headpin dangle. Add several beads and create a gallery wrap for a finished look.
Step 8
To create a gallery wrap, grasp the wire next to the bead and bend it at a 45 degree angle. Move the pliers so that one jaw is above the wire and one jaw below it. Bring the wire up and over the top jaw and bend it straight down. Move the pliers and put the bottom jaw in the loop. With your hand, wrap the bent wire around the straight piece laying them side-by-side and tightening the bead in place.
Step 9
Carefully snip off any excess wire and make sure it is smooth.Add the dangle to the loop and gently close the loop.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

All products sold by Fire Mountain Gems and Beads® are not intended for use by children 14 years of age and under.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.