Close
Home
Jewelry Making How-To Videos

Free Beading Instructions > How-To Videos > Beaded Mesh Pencil Holder

 Beaded Mesh Pencil Holder 

by Lisa from Fire Mountain Gems and Beads
4B24


Looking for a fun, easy-to-complete project that turns the mundane into the delightful? Use Celestial Crystal and aluminum roses to turn an ordinary mesh pencil cup into desktop art with a practical side. Follow the detailed step-by-step instructions provided. There's a complete materials list, and we offer all of the beads, wire, and tools needed. Just get a mesh pencil cup (available at most office supply stores), and you're ready to transform the ordinary into the extraordinary.


: : : Materials : : :
End of Materials List
Step 1
Cut three 24-inch lengths of wire. Twist a small loop at one end of each wire. This will prevent the beads from coming off while stringing.
Step 2
String 31 crystal flat rounds onto each wire strand. Alternate the colors.
Step 3

Starting just under the rim of the pencil holder, twist the end of the first beaded wire strand around the mesh of the holder. Wrap the beaded wire around the holder exterior. Twist the end of the second wire around the mesh, so that the two ends of the strands meet up with one another. Attach the third wire strand beginning on the same side of the holder, to create a back side of the vessel. The bead strands will hang loosely and will be tightened later.
Step 4
Cut thirty-one, 12-inch long strands of beading wire.
Step 5
Add a large purple crystal onto one wire, leaving a 1-1/2 inch tail. Wrap the tail up behind the purple crystal. Twist the wire tail around the remaining length of wire tightly, 3 - 4 times to secure. Add a small purple crystal, threading it over the excess wire tail. Add the following sequence of beads: large purple, small purple, large purple, small purple, large purple, small purple and large purple. Thread the remaining length of wire through the pencil holder at the base of the lowest beaded strand between two crystals. Weave and wrap the excess wire up and over the three wrapped strands to secure them to the holder.
Step 6
Wrap the remaining wire several times through the mesh just under the rim of the holder to secure. Trim the excess with the wire nippers.
Step 7
Create another strand as in Step 6 using the following sequence: small purple crystal, large pink crystal, small purple crystal, large pink crystal, small purple crystal, large pink crystal, and small purple crystal, large pink and small purple.
Step 8
Wrap and secure this beaded strand between the next two crystals, along the lower row of strands, following the directions to secure and finish as in Step 6.
Step 9
Create more large purple-small purple strands, and more large pink-small purple strands.
Step 10
Attach all of the beaded strands as explained in Steps 5 - 8, alternating the different sequence strands until the dangling crystal extensions wrap around the entire holder.
Step 11
Attach alternating colors of the large aluminum roses (pink and lavender) to the large purple crystals at the top of each dangling strand.
Step 12
Glue alternating colors of the small silver and purple aluminum roses to the top of the holder rim with two-part epoxy. (Note: Allow the epoxy to fully cure for at least 24 hours).

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.