%>
Close
Home
Jewelry Making How-To Videos

Free Beading Instructions > How-To Videos > Finishing Memory Wire Jewelry

 Finishing Memory Wire Jewelry 

Presented by Arbel, Advertising Designer, Marketing Events Group,
Exclusively for Fire Mountain Gems and Beads®
690Q

There are two ways to finish the ends of Memory Wire. You can finish with ball ends or by turning each end into a loop.


: : : Materials : : :
End of Materials List

To Finish with Beads:

Step 1
Insert the tip of the glue into the bead end. Squeeze the glue so you fill the cavity of the bead.
Step 2
Insert one end of the Memory Wire into the bead end and hold it there for a few seconds. Set the wire aside so the epoxy can cure completely (5 minutes) before stringing your beads. Once the glue is dry, begin stringing your beads. Finish the other end by following these steps again. Let the glue dry overnight before wearing your finished piece.

To Turn the End Into a Loop (no ball ends or Epoxy needed):

Step 1
Grip the end of the memory wire in the nose of your round-nose pliers and hold firmly.
Step 2
Rotate your wrist away from your body, forming a loop in the wire. Begin stringing your beads. Finish the other end by following these steps again. To enhance your design, you can hang a charm off the end. Click here to learn how to make a simple loop or wrapped loop.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.