Crimping with Screw-Tite Crimps™727G
Screw-Tite Crimps™ are a secure way to connect your beading wire to a finding, such as a clasp. What makes this style crimp different from other crimps is that it is secured in place with a set screw. And not only is this crimp secure it can also be removed at any time. This feature allows you to change your beaded design or clasp, should you decide you want a different look.
Using the Screw-Tite Crimps™ screwdriver, loosen the set screw in the side of the crimp until it can accommodate two passes of the wire. Do not loosen too much, as the set screw will fall out. Pass one inch of the Accu-Flex® beading wire through the flat end of the crimp.
Pass the end of the Accu-Flex® beading wire through one tube of the wire protector and back through the second tube. Slide the end of the clasp onto the Accu-Flex® beading wire then down into the bend in the wire protector. Thread the Accu-Flex® beading wire back through the crimp finding then pull the Accu-Flex® so there is no slack in the wire between the crimp and the wire protector.
For complete instructions on using Accu-Guards™ wire protectors, visit the FREE instruction link below.
Tighten the set screw with the Screw-Tite Crimps™ screwdriver, and give a tug on the Accu-Flex® beading wire to ensure a secure fit.