 |
|
printer friendly versionUsing Accu-Guard™ Wire Protectors
727H
: : : Materials : : :
Alternative Materials:
Accu-Guard™ wire protectors Accu-Flex® professional-quality beading wire Crimp tubes
Step 1
Cut a piece of Accu-Flex® Professional-Quality Beading wire to the size needed for your beading project.
Step 2
 |  | Pass the end of the Accu-Flex® beading wire through a crimp tube and through the tube on one side of the wire protector. You will notice that there is a tube on each end of the wire protector, with a channel in between.
Pass the Accu-Flex® beading wire through the other tube then tighten. As you tighten the Accu-Flex® beading wire will lay flush in the channel. |
Step 3
 | | Add one half of your clasp by sliding the loop up into the curve of the wire protector. Pass the Accu-Flex® beading wire back through the crimp bead and crimp using crimping pliers. Using wire cutters, trim any excess Accu-Flex®. |
Step 4
String your beads onto the Accu-Flex®.
Step 5
To finish, repeat Steps 2 and 3 using the other half of the clasp. Pull the Accu-Flex® to make sure there is no slack along the length of the design. Crimp the bead to secure.
: : : Additional Resources : : :
Have a question regarding this project? Email Customer Service.
Copyright Permissions
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.
