Close
Free Pair of SWAROVSKI ELEMENTS 12mm Butterfly Beads with Swarovski Crystal Purchase
Jewelry Making How-To Videos

Free Beading Instructions > How-To Videos > Inserting a Saw Blade into a Jeweler's Saw Frame

 Inserting a Saw Blade into a Jeweler's Saw Frame 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
A138

We're sorry, your browser does not have the necessary Flash player installed to view the content you selected.

Get Adobe Flash Player
click hereto install the latest Flash Player.
**Before installation, please close all other open browser windows.
: : : Materials : : :
End of Materials List
Step 1
Untwist the wire around the bundle of saw blades until you can pull one out easily (twist the wire back around the blades once you have one out).

Loosen the two wing nuts on either side of the opening of the jeweler's saw frame.

Prop the far end of the saw frame against the edge of a table or desk. Hold the handle and push the frame end against the table with a steady pressure, yet without bending the saw frame.
Step 2
The blades in this frame type are slightly stretched, much like stringing an archery bow, so insert the blade end into the clamp nearest the handle first and tighten firmly. Be sure the teeth are facing up and so that they are either in a down or upward position--cutting in either the push or the pull stroke (this is a personal preference).
Step 3
Insert the far end of the blade into the frame, tighten slightly and release the pressure against the table or desk edge. Tighten the far end firmly. Pluck the blade--if you get a tinny or flat note, reposition the frame on the table, push on the handle a little more firmly, release the wing nut on the far end, reposition the blade and tighten the wing nut.

Repeat until the sound you hear is a good note, indicating the blade is ready to cut metal.

When using this type of blade, avoid pushing the blade against the metal being cut; it will catch and snag, damaging the metal or breaking the blade. Using a gentle up and down motion, pushing the blade forward slightly, let the teeth of the saw blade do the work of cutting the metal.
: : : Additional Resources : : :
  • ''Sawing Metal'' how-to video and instructions
  • End of Additional Resources

    Have a question regarding this project? Email Customer Service.

    Copyright Permissions

    Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

    All products sold by Fire Mountain Gems and Beads® are not intended for use by children 14 years of age and under.

    Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
    Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.