Close
Home
Jewelry Making How-To Videos


 Steel Hole Punch, How-To 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
A13W

The easy way to use a steel hole punch, makes holes with smooth edges and a good round shape. Holes can be made in soft metal of varying thickness, ranging from 28-gauge (approximately .3mm) to 10-gauge (approximately 2.6mm) depending on the type and hardness of the metal. The hole punch creates hole sizes in approximately 1.5mm (accommodating up to 14-gauge wire) and 2mm (accommodating up to 12-gauge wire) in diameter.


: : : Materials : : :
End of Materials List
Step 1
Slide a piece of metal into the opening at the end of the tool with the desired hole-punch size. Position the metal so the hole will be in the desired location.

Position the metal so the hole will be in the desired location.
Step 2
Slowly twist the handle in a clockwise motion, lowering the punch into position.
Step 3
Continue to twist the handle as the punch makes contact with the metal you are punching. You will feel a resistance. Twist until the hole has been made all the way through.
Step 4
Once the hole is completed, turn the handle counterclockwise to raise the punch and release the metal.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.