Close
Home
Beading Instructions

Beading Resources > Free Beading Instructions > > Disc Cutter, How-To

 Disc Cutter, How-To 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
A13Z
: : : Materials : : :
End of Materials List
Beader's Tip: For clean cuts, practice on less expensive metals first.
Step 1
Remove all punches from the steel disc cutter.
Step 2
Slide the metal item or sheet between the plates of the disc cutter.
Step 3
Place the size punch you want into the appropriate opening on the cutter base, putting the end of the punch that is flush (not rounded) into the opening. Using the mallet, brass and nylon hammer, or hammer of your choice hit the punch gently and repeatedly until the punch pushes through the metal. Make sure to keep the metal sheet stable while you are striking the punch--any movement will cause the punch to leave marks on the metal sheet and not give you a clean disc.
Step 4
Remove the sheet from the cutter; the cut-out disc will be separate from the sheet.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.