Using the scissors, cut two 1/2 inch lengths of French wire. Using side-cutting pliers, cut a length of Accu-Flex® professional-quality beading wire appropriate for your project needs.
String onto the wire one crimp tube, a 1/2 inch piece of French wire and the loop on one half of the clasp. Pass the wire back through the crimp tube, leaving one end of the wire approximately 1-inch long.
Pull the crimp tight against the French wire and the clasp so the French wire forms a nicely curved tube.
Using the crimping pliers, crimp the crimp tube. Using side-cutting pliers, trim the excess wire from the short end.
String on the beads for your design. Repeat Step 2-3 to secure the second half of the clasp.
For a more finished look, place a crimp cover over the crimped crimp tube, then gently close it using the front notch on the crimping pliers.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email email@example.com for more information.