Close
Home
Beading Instructions

Beading Resources > Free Beading Instructions > > How To Set Up and Polish with the Polisher Bench Lathe

 How To Set Up and Polish with the Polisher Bench Lathe 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
A53K


: : : Materials : : :
End of Materials List
Use caution when setting up and polishing using the Bench Lathe.
Step 1
Secure bench lathe to your work surface using either the suction cup feet or by installing bolts through the mounting holes found in the base.
Step 2
Connect the spindle/mandrels to the motor shaft.
  • Determine which spindle is for the left side and right side (find the L or R marker on the spindles).
  • Slide the spindle onto the appropriate motor shaft.
  • Line up the set screw with the flat side on the motor shaft.
  • Leave 1/8 inch space between the motor housing and the inside edge of the spindle or mandrel.
  • Using the supplied hex key, tighten the set screw to secure the spindle or mandrel in place.
Buffing wheels are spun onto the spindles and mandrels to secure them in place.

To charge a wheel with a compound for polishing metal:
  • Turn the bench lathe on then place the selected compound against the lower front section of the wheel.
  • Hold until the wheel is charged.
  • Do not apply too much compound --too much compound could make the finish of your work hazy (it can be buffed off but that is one more step).
    • If you apply too much compound, it will wear off eventually; all is not lost.
  • Once a wheel is charged with one compound it is best to not use this wheel for any other compound.
  • As you buff or polish a piece, wash it off before moving onto the next compound or you will contaminate the wheel, bringing in a more coarse grit from the polish before.
  • If this occurs, transition this buff to the lower grit compound then start a new wheel to replace the contaminated one.
  • Label all wheels to indicate which compound it holds.
Once the wheel is charged you can begin buffing and polishing metal items.

When buffing then polishing, move through the various grits, working from most coarse to finest polish, until you are pleased with the results.

Polishing Cured Polymer
  • For optimum results, sand the cured polymer to a fine-grit sand paper polish before polishing with the Bench Lathe.
  • Do not charge the buffing or polishing wheel with any compound.
  • Move the cured polymer around; do not hold in one spot for too long.
    • If held in one spot, polymer will heat up and begin to melt as well as grab fibers from the wheel.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.