%>
Close
Home
Beading Instructions

Beading Resources > Free Beading Instructions > > Riveting With a Wire Rivet

 Riveting With a Wire Rivet 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
A55U

Riveting is a cold-joining process, bringing two pieces of something, in this case metal, together. A wire rivet is formed into a nail-like head on each end, with the layers to be joined sandwiched in between then held in place.


: : : Materials : : :
End of Materials List
Step 1
Check to make sure the end of the 14-gauge wire is cut flush or has a blunt cut end; trim using flush-cutters, if not. Insert the wire into the vice so about 1/2 to 1-inch of the wire is above the vice surface.
Step 2
Using the ball-peen hammer, strike the end of the wire as if drawing the wire out from the center to the side. Repeat working around the entire end of the wire. Repeat until you can feel you have established a head on the end of the wire, something that feels like a nail head.

Cut about 1/2-3/4 inches below the end you just formed. Set the rivet aside.
Step 3
Prepare the pieces to be riveted, placing holes in them to match the gauge of the wire.

For 14-gauge wire, the smaller hole (1.5mm) on the steel hole punch works perfectly.
Step 4
Stack the layers to be joined. Insert the wire through the hole so the nail head of the rivet is on the front.
Step 5
Place the layered items, with the rivet in place, face down on a bench block. Using flush-cutters, trim the wire about 2mm above the surface of the last layer.
Step 6
Using a ball-peen hammer, begin to form the nail head in the wire, working the same way you did for the other end. Check the assembly to make sure everything is lined up as you like. Adjust if necessary. Hit the wire again to ensure the join.
: : : Additional Resources : : :
End of Additional Resources

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.