%>
Close
Home
Beading Instructions

Beading Resources > Free Beading Instructions > > Finishing Cording with a Pop-Clasp

 Finishing Cording with a Pop-Clasp 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
BB9G
: : : Materials : : :
End of Materials List
Step 1
Cut 3mm cording to your desired length.
Step 2
Dispense an equal amount from each part of the epoxy. Mix well.
Step 3
Dip one end of the cording into the epoxy, gathering a light coating.
Step 4
Insert the end into one half of the pop clasp. Repeat on the other end of the cord with the other half of the clasp. Allow the epoxy to cure overnight.

To use the pop clasp, push the smaller end of the clasp into the larger end; ensure it is secure. Pull the two halves apart to release.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.