Close
Free Pair of SWAROVSKI ELEMENTS 12mm Butterfly Beads with Swarovski Crystal Purchase
Beading Instructions

Beading Resources > Free Beading Instructions > Tutorials > Fusing Glass Frit in a Slumping Mold

 Fusing Glass Frit in a Slumping Mold 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
BBB9
: : : Materials : : :
End of Materials List
Step 1
Following manufacturer's instructions, create kiln wash using glass separator or kiln wash. Using a 1-inch brush, apply 3 - 4 layers of kiln wash to the mold, covering the entire depression. Allow the kiln wash to dry completely between layers and have the last layer be completely dry before using.
Step 2
Pour frit into the depression in the mold, filling it to the top.
Step 3
If the design has a "bump" in the mold for creating a hole in the fused design, be sure to leave the area clear.




Place the mold onto ceramic posts or a kiln shelf, inside the kiln. Set the controller for a full fusing.

The schedule used for the pieces shown is:
  • Ramp 1 - 900°F/hour to 1000°F. Hold for one minute.
  • Ramp 2 - FULL speed to 1480°F. Hold for 15 minutes.
  • Ramp 3 - FULL speed to 1100°F. No hold necessary.
  • Ramp 4 - 300°F/hour to 955°F. Hold for 15 minutes. Allow the kiln to cool to room temperature, or no higher than 100°F, before opening and removing the mold. Adjust the schedule based on your results.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

All products sold by Fire Mountain Gems and Beads® are not intended for use by children 14 years of age and under.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.