%>
Close
Home
Jewelry Making How-To Videos

Free Beading Instructions > How-To Videos > How-To Videos Search Results > Using Brads and Washers on Leather

 Using Brads and Washers on Leather 

Instructions by Michelle Wood, Jewelry-Making Expert, Exclusively for Fire Mountain Gems and Beads®
C21P

We're sorry, your browser does not have the necessary Flash player installed to view the content you selected.

Get Adobe Flash Player
click hereto install the latest Flash Player.
**Before installation, please close all other open browser windows.
: : : Materials : : :
End of Materials List
Step 1
After punching a hole in the leather, lay the washer or component over the hole and push the brad through both pieces.
Step 2
While holding the brad and washer in place, turn the leather over and lay it on a metal block.

Add a flat washer to the brad then trim the brad with side-cutters to about 2mm above the flat washer.
Step 3
Using a ball peen hammer, hammer the brad flat against the washer securing the components in place.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.