How to Use the Crystal Applicator™ Tool and 4-Piece Snap Die Set DA6U
Identify (A) upper and (B) lower die holders on tool.
Ensure tool handles can be closed completely. If necessary adjust with (C) stroke adjustment screw.
To apply front of snap to material, identify Front Die Set (SN001F) and attach upper and lower dies to die holders A and B on tool.
Insert Swarovski snap front components in appropriate Front Dies. This operation includes the decorative snap front. (To match correct dies and components, see details in Fig. 2)
Place material face down over lower die and squeeze handles, attaching stone to material. Release tool and gently pull material to remove from tool.
To apply back of snap to material, remove upper and lower dies and repeat Steps 3 - 4 with Back Die Set (SN001B) and snap back components.
IMPORTANT: For bracelet application, be sure material is face up when performing this operation.
Release tool and gently pull material to remove from tool. Front and back snaps are now applied.
Wear and enjoy!
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email
for more information.