Close
Home
Beading Instructions

Beading Resources > Free Beading Instructions > Tutorials > How to Create a European 4-in-1 Chainmaille Pattern

 How to Create a European 4-in-1 Chainmaille Pattern 

by Tammy Honaman, Author, Jewelry-Making Expert and Educator, Exclusively for Fire Mountain Gems and Beads®
E50Q
Design Idea E503 Bracelet
Design Idea DA5L Necklace and Earrings
: : : Materials : : :
End of Materials List
Historically, this pattern was used to create armor and other forms of clothing and accessories. This is due to the fact that the weave allows for movement or stretching from side to side and not top to bottom, and that it is easily adapted to shape and size of a person or animal.

There are many ways to create this chainmaille pattern. I’ve used two different colored rings to help illustrate the method I used.
Step 1
Open one jumpring then thread on four closed jumprings. Close the open jumpring.
Set the rings so they lie flat and so rings overlap and rest as shown; this is key to the success of this pattern.
Step 2
Weave an open ring into the two top rings on the left and right of the center ring, being careful to not disturb their arrangement.

Tip: Place a piece of tape on the established rings to keep them in line.
Step 3
Add two new closed jumprings to the open jumpring then close the jumpring. Set the two new rings into position as seen. If for any reason they do not work into the weave as shown, remove and reposition.
Repeat Step 3 until you have a weave as long as you like.

To Widen the Weave

Step 4
Turn the woven chainmaille 180 degrees. Add one new jumpring to a jumpring at the top along the right side. As shown, this is done on the end where the last ring is on the top of the weave.
Step 5
Add a ring to the next ring down in the outside row, working from underneath up to the top then through the first ring, making sure the new ring passes through where the first and second overlap.
Repeat to add rings to the entire row.
Step 6
If adding another row--remove the first ring added in Step 4.

Add one new jumpring to the ring now at the top along the end, as shown.
Step 7
Add a new jumpring through the second ring in the outside row, working from top to bottom and through the first ring where it is overlapped by the second ring.
Step 8
Repeat Step 7 to add rings to the entire row; add one ring to the last ring in the previous row so the new ring rests into the weave according to the pattern.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.