Bracelet with Gemstone Beads, Wood Beads and Oh! Ring™ Rubber Components

STEP 1
Using scissors cut one 12-inch length of 1mm Powercord® elastic cord.

Give the cord several stretches to condition it.

Attach one Bead Stopper™ to one end of the Powercord.
STEP 2
String the following onto the Powercord:
  • Five sets of one Oh! Ring™ rubber component and one red tigereye 6mm round
  • One ring component
  • One lime green wood 6mm round
  • One ring component
  • One rose riverstone 6mm round
  • One silver-finished mini chip
  • One tiger iron 14x10mm rectangle
  • One silver-finished mini chip
  • One green agate 8mm round
  • One ring component
  • One rose riverstone 6mm round
  • Four sets of one ring component and one red tigereye 6mm round
  • One ring component
  • One lime green wood 8mm round
  • Six sets of one ring component and one red tigereye 6mm round
  • One ring component
  • One rose riverstone 6mm round
  • Two sets of one silver-finished mini chip and one rose riverstone 6mm round
  • Five sets of one ring component and one red tigereye 6mm round
  • One ring component
STEP 3
Remove the Bead Stopper and tie the ends of the Powercord together using a surgeon’s knot.
STEP 4
Add a small amount of GORILLA™ glue to the knot and slide the first and last ring components strung over the knot to conceal. Let glue dry per the manufacturer's recommendation.
STEP 5
Once the glue is dry, trim off the excess cord close to the ring components.

: : : Additional Resources : : :

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

Have a question regarding this design idea? Email Customer Service.

Recommended Just for You