Gallery of Designs
Single-Strand Necklace with Silver-Plated ''Pewter" Charm, Black Onyx Cabochons and Antique Silver-Plated Steel Focals
Frosty the Angel
-- Designer --
Anita M. Russell
To learn more about Anita Russell, read her jewelry artist success story here
- Cabochon, black onyx, 6mm calibrated round (1 cabochon)
- Cabochon, black onyx, 8mm calibrated round (1 cabochon)
- Cabochon, black onyx, 10mm calibrated round (1 cabochon)
- Charm, silver-plated ''pewter'' (zinc-based alloy) and enamel, white / green / red, 22x19mm single-sided snowman head with glittery face, top hat, scarf and carrot nose (1 charm)
- Focal, antique silver-plated steel, 30x18mm single-sided fancy butterfly (1 focal)
- Focal, antique silver-plated steel, 40x27mm double-sided filigree teardrop, 6 loops (1 focal)
- Loop Lock, JBB Findings, gunmetal-plated brass, 10mm round (1 loop lock)
- Chain, gunmetal-plated brass, 2.5mm cable, 18 inches with 1-1/4 inch extender chain and lobster claw clasp
- Adhesive, E6000 Jewelry and Craft Adhesive, clear
- Pliers, chain-nose
STEP 1
|
|
Use E6000® Jewelry and Craft Adhesive to glue the 22x19mm snowman head to the top of the front side (smaller end) of the 40x27mm filigree teardrop "body." Set aside to dry. |
STEP 2
|
|
Glue the black onyx cabs down the center of the body (as shown), smallest just below the snowman head to largest at the bottom. Set aside to dry. |
STEP 3
|
|
Glue one 30x18mm fancy butterfly "wings" to the back side of the body, directly behind the snowman head. Set aside to dry. |
STEP 4
Pass one 10mm jumpring through the loop on the snowman head and 2.5mm cable chain then close.
Wear and enjoy!
The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We
encourage you to substitute different colors, products and techniques to make the design your own.
Have a question regarding this design idea? Email Customer Service.