|Determine the number of loops you want to use for your project and cut the wire. 6 loops were used for the bracelet.|
|Determine if you will have a center motif (you would begin the design by taping off the other side and creating a pattern that would be mirrored on the other side. Or simply lay out the design on the board.|
|Before adding the beads, bend a loop on one end by taking your round-nose pliers and bending the loop toward you (not closing it completely)|
|Add beads--just like stringing but with no needle. Add beads in the following order and repeat the pattern to the desired length. (See materials list for bead descriptions) #1, #2, #3, #2, #1, #4, #3, #4.|
|Add a headpin dangle. Add several beads and create a gallery wrap for a finished look.|
|To create a gallery wrap, grasp the wire next to the bead and bend it at a 45 degree angle. Move the pliers so that one jaw is above the wire and one jaw below it. Bring the wire up and over the top jaw and bend it straight down. Move the pliers and put the bottom jaw in the loop. With your hand, wrap the bent wire around the straight piece laying them side-by-side and tightening the bead in place.|
|Carefully snip off any excess wire and make sure it is smooth.Add the dangle to the loop and gently close the loop.|
Have a question regarding this project? Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email email@example.com for more information.