Close
Home

Four Leaf Clover Bracelet and Earrings

Instructions provided by WigJig
A76L

-- Designer --

STEP 1
Cut a piece of 20-gauge wire 2-1/4 inches long.
STEP 2
Make a loop in the end of the wire with the flush-cutters.
STEP 3
Straighten this wire segment with your nylon jaw pliers.
STEP 4

Position pegs 1 and 2 in your jig. Place your initial loop on peg 1 and wrap the wire around peg 2. Please note that there are two peg patterns shown for making this 4 Leaf Clover wire component. The smaller pattern on the right is slightly more difficult to finish.
STEP 5
At this point you need to remove the wire from the jig and add peg 3 to your pattern. Replace the wire on the jig with the initial loop on peg 1 but with the loop made on peg 2 being placed on peg 3 instead.
STEP 6
Now wrap the wire around peg 2 again, leaving the wire adjacent to the hole for peg 4.
STEP 7
Add peg 4 and wrap the wire around this peg.
STEP 8
Remove the wire from the jig and cut the excess wire. Close the final loop with your bent chain-nose pliers.
STEP 9
Flatten and harden the finished piece by squeezing it in the jaws of your nylon jaw pliers.
STEP 10
Make a total of seven of these 4 Leaf Clover wire components.
STEP 11
Connect all seven wire components with wrapped bead links using 22- or 24-gauge wire.
STEP 12
Connect the two wire components on the end to your clasp. If you use magnetic clasps use a guard chain made of fine commercial chain.
STEP 13
Make matching earrings using either pattern shown.

: : : Additional Resources : : :

  • For more information on this pattern, please visit http://www.wigjig.com

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.