Get inspired by Swarovski design team's limitless imagination. Magical project ideas bring a new dimension to simple techniques.
Cut 90-cm of 0.2mm nylon thread and slide on 4 Beads from our Swarovski crystal assortment, article 5000, 2mm in Crystal Silver Shade. Now go through the last Bead with both the thread ends so that a circle is formed as shown in the illustrations of this step.
Slide on one more Bead and cross thread ends through it. Now slide onto each thread end one more Bead and cross over through the third Bead. Now fix it by sliding in the thread end through the two Beads once more as being depicted in the illustrations in this step.
Slide on a new Bead and cross over both thread ends through it. Now slide on to each thread end two more Beads and cross through the fifth one. Now secure this row by threading in twice through the last Bead from the previous row as shown in the illustration for this step.
Repeat step 3 to have another row of Beads but slide on three Beads on each end this time and secure this row too as being clearly shown in the illustrations with this step.
Repeat step 3 two more times to add two more rows of Beads to the structure. Now slide in from our Swarovski crystal assortment article 6690 27mm Crystal Silver Night. Slide both thread ends through the hole of the pendant and cross threads through opposite Beads, then with each thread end go back through the Beads to the point at where actually the process started and pull tight. This action has been shown clearly in the illustrations with this step.
Repeat step 3 and thread in this time 5 Beads on both the thread ends and cross over through a new Bead. Repeat step 5 and secure this row too with the previous row as shown in the illustrations in this step.
Now repeat step 6 adding on 6 more Beads on each thread end and crossing over again through a new Bead. Secure this row with the previous row as shown in the illustrations in this step.
Now slide both thread ends through the entire circle row of last Beads and cross over again through the last Bead. Now slide thread ends in an upward direction cut them off.
Open the French earwire and slide in the structure prepared in the previous step, close the French earwire and you already have an earring. Repeat all these steps once more to prepare the other set of earring.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction
requires written permission. Please email email@example.com
for more information.