|Using hole punch pliers, punch a hole in the metal sheet, lay the finding over the hole then insert brad.|
|Hold the brad and finding while turning the metal sheet over, then place on metal block. Place a flat washer onto the brad; trim the brad with flush cutters to about 2mm above the washer.|
|Using a ball peen hammer, hammer the brad until flat.|
Have a question regarding this project? Email Customer Service.
Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists; children 14 years of age or younger should use these products with adult direction.
Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA
Copyright 2008-2017 Fire Mountain Gems and Beads, Inc. All rights reserved.
Fire Mountain Gems and Beads reserves the right to make policy changes at any time without prior notice.