Cleaning a Clay Extruder

by Tammy Honaman, Author, Jewelry-Making Expert and Educator,
Exclusively for Fire Mountain Gems and Beads®
CB53

Once you are done using your extruder, it’s a good idea to make sure it is cleaned thoroughly before storing.

: : : Materials : : :

STEP 1
Remove the bottom cap from the barrel.

Note: The disc may remain in the cap, if so, remove and clean any clay remaining on the disc.

Tip: If working with metal clay, save the clay you collect then add it to your fresh clay or use to make your own metal clay slip (paste).
STEP 2
Remove the T-handle end from the barrel.

Note: The disc may remain on the clay on the plunger, remove the disc then clean any remaining clay from the surface. Remove any clay from the plunger.
STEP 3
Use a tool to remove the oh-ring from around the end of the plunger, then clean the ring and under and around where it rested.
STEP 4
Use a tool to clean the inside of the barrel.
STEP 5
Use a pointed tool to clean the inside ridges of the cap of the barrel.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.