Beadalon® Flat Memory Wire Findings

Courtesy of Beadalon
F36D
STEP 1
Glue Component to Back of Focal Place the focal component face-down on a flat surface and place a small drop of epoxy on the back of the focal. Press the slider component onto the glue. Let it dry.
STEP 2
Cut Memory Wire Use memory wire shears to cut a single loop off the ring-size coil of memory wire so there is a gap of about 1/8 inch between the ends.
STEP 3
Slide Component onto Wire Slide the focal component onto the center of the wire.
STEP 4
Glue End Caps to Ends of Memory Wire Glue a flat memory wire end cap to each end of the wire.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Sign Up for Email Specials and Beading News
Just Sign Up
for Email Specials and Beading News