Single-Strand Necklace and Earring Set with White Lotus™ Pearls, Mystic Topaz Gemstone Beads and Crystal Passions® Beads

Hover over to zoom.

Design Idea KA0C

-- Designer --

Jude, Jewelry Artist, Exclusively for Fire Mountain Gems and Beads®

To learn more about Jude Wroblewski, read her jewelry artist success story here.

: : : Materials : : :

Please take the creative opportunity to select the products of your choice for this design, offered here at Fire Mountain Gems and Beads.

Instructions

Necklace Instructions

Step 1

Cut a 36-inch length of Accu-Flex® professional-quality beading wire and a 4-inch length of long and short chain.

Step 2

String a paradise shine 3mm bicone and a mauve 6mm rice pearl onto a head pin then create a simple loop.

Use a 4mm jump ring to add the drop to the last link of the length of chain.

Step 3

String a crimp and an Accu-Guard™ wire protector onto the beading wire. Pass the beading wire back through the crimp. Pull the beading wire so the crimp rests snug against the Accu-Guard leaving approximately 1/4 inch of beading wire on the end. Crimp, trim the excess wire and add a crimp cover.

Step 4

String the following onto the beading wire:

One pearl
The first hole of an 8.5mm spacer bar
Three 3mm bicones

Pass through the second hole of the spacer bar in the opposite direction and pull the wire tight to create a half circle with the 3mm bicones.

Step 5

String the following onto the beading wire:

One pearl
The first hole of a spacer bar
One 3mm bicone
One mystic topaz teardrop
One 3mm bicone

Pass through the second hole of the spacer bar in the opposite direction and pull the wire tight.

Repeat 5 more times.

Step 6

Repeat Steps 3 and 4 in reverse to complete the beaded strand.

Step 7

Use 4mm jump rings to add a lobster claw clasp to one end of the necklace and the first link of the length of chain to the other end.

Earring Instructions

Step 1

Cut two 6-inch lengths of 24-gauge wire.

Step 2

String a mystic topaz teardrop onto a length of wire. Position the teardrop approximately 1 inch from the end of the wire.

Bring both sides of the wire together above the tip of the teardrop, then wrap the short end around the long end three times. Trim any excess wire from the short end.

Step 3

String a mauve 6mm rice pearl onto the straight end of the wire then create a simple loop.

Step 4

Repeat Steps 2 and 3 to create a second drop.

Step 5

Add an ear wire to the simple loop of each drop.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.