Wedding Table Plaque with Dance With Me™ Crystal Flat Backs

STEP 1
Cut an 18-inch length of 18-gauge wire.
STEP 2
At the approximate end of the wire, make a 45-degree bend. Use your fingers to gently curve the wire into a heart shape.
STEP 3
As the wire finishes the bottom of the heart shape, curve the wire up and around the heart in a circle on the same plane as the heart.
STEP 4
Wrap the wire around the tail directly below the bottom of the heart three times. Trim excess wire from the wrap.
STEP 5
Approximately 3/4 of an inch from the wraps, bend the tail at a 90-degree angle perpendicular to the heart/circle.
STEP 6
Approximately 3/4 of an inch down the wire make a 45-degree bend. Use your fingers to gently curve the wire into a heart shape perpendicular to the heart/circle. Trim any excess wire.

: : : Additional Resources : : :

  • ''Glues'' how-to video and illustrated instructions

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

Have a question regarding this design idea? Email Customer Service.