Single-Strand Necklace and Earring Set with Swarovski Crystal and Almost Instant Jewelry® Drops and Links

Necklace

STEP 1
Mix Devcon® 5-Minute® Epoxy according to manufacturer's instructions.

Apply a thin layer of epoxy along the edge of the bezel in the center of one silver 15.5x15.5mm square link and around the back edge of one Swarovski crystal mahogany 10x10mm cushion embellishment. Press the embellishment into the setting then allow the link to set for 5 minutes.

Repeat to create a total of two silver links, two gold links and one gold drop.
STEP 2
String onto one 2-inch eyepin one Swarovski crystal mahogany 6mm bicone, one Swarovski crystal lilac shadow 8x6mm rondelle and one mahogany 6mm bicone them form a simple loop. Repeat to create a total of four Swarovski links.
STEP 3
Cut two 4-1/2 inch lengths of 4mm rolo chain.

Using one 4mm jumpring connect one lobster claw clasp to the first link on one 4-1/2 inch length of rolo chain.
STEP 4
Continue to connect the following using 4mm jumprings:
  • One gold link
  • One Swarovski link
  • One silver link
  • One Swarovski link
  • One gold drop
STEP 5
Using one 4mm jumpring connect one 6mm jumpring to the first link on the second length of chain then repeat Step 4 to create the second half of the necklace.

Earrings

STEP 1
Mix epoxy according to manufacturer's instructions.

Apply a thin layer of epoxy along the edge of the bezel in the center of one silver 15.5x15.5mm square link and around the back edge of one Swarovski crystal mahogany 10x10mm cushion embellishment. Press the embellishment into the setting then allow the link to set for 5 minutes.

Repeat to create a second silver link.
STEP 2
String onto one 2-inch eyepin one Swarovski crystal mahogany 6mm bicone, one Swarovski crystal lilac shadow 8x6mm rondelle and one mahogany 6mm bicone them form a simple loop. Repeat to create a second Swarovski link.
STEP 3
Using one 4mm jumpring connect one silver link to one loop on the Swarovski link.

Open the loop on one fishhook earwire and pass it through the loop on the opposite end of the Swarovski link then close.
STEP 4
Repeat Step 3 to create a second earring.

: : : Additional Resources : : :

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

Have a question regarding this design idea? Email Customer Service.

Recommended Just for You