Bracelet with Miyuki Seed Beads

STEP 1
Prepare the beading loom with 10 warp threads (one more thread than the number of beads used in the design), spaced approximately 2mm apart.
STEP 2
Cut a 3-foot length of black size D Nymo® thread. Thread a beading needle, doubling the thread. Pull one thread end to create a tail that is approximately five inches. Temporarily tie the tail to the side rail of the loom.

Note: It may be necessary to cut additional lengths of thread later in the design. If there are 6 inches or less of thread remaining, weave the remainder through adjacent beads to secure. If desired you can first knot the thread. Start a new length of thread in the same way--passing through several beads and exiting from the point where you left off.
STEP 3
String the following onto the beading needle:
  • Three silver 1.8mm square seed beads
  • Three dark gold 1.8mm square seed beads
  • Three gold 1.8mm square seed beads
Hold the needle behind the warp threads. Use your finger to press the seed beads into place. (Each bead will be placed between two warp threads.) Hold the beads in place with your finger and pull the needle and thread through the seed beads.

Pull the thread taut. Pass back through the seed beads, ensuring that the needle is in front of the warp threads.
STEP 4
Untie the thread tail from the loom. Tie the tail and the working thread close to the seed beads to secure.
STEP 5
Repeat Step 3 using the following square seed beads:
  • Row 2: three silver, three dark gold, three gold
  • Row 3: three silver, three dark gold, three gold
  • Row 4: three gold, three silver, three dark gold
  • Row 5: three gold, three silver, three dark gold
  • Row 6: three gold, three silver, three dark gold
  • Row 7: three dark gold, three gold, three silver
  • Row 8: three dark gold, three gold, three silver
  • Row 9: three dark gold, three gold, three silver
Repeat the pattern until the desired length is reached.
STEP 6
Pass the needle through several adjacent seed beads on several rows. This secures and hides the thread. Trim the excess thread. Thread the needle onto the thread tail and repeat.

Separate one warp thread from the loom, keeping the others secure, and repeat. Repeat to secure both ends of all warp threads.
STEP 7
Insert the first row of the seed bead strip into the tube slot of one 20x4mm end bar. Press the end cap on the end bar to secure the strip into place.

Repeat with the opposite end of the seed bead strip and a second end bar.
STEP 8
Pass a 6.5x5mm oval jumpring through a loop of a silver-plated and rhinestone spacer bar, then close.

Attach an oval jumpring to the loop of each half of the toggle clasp.

Pass an oval jumpring through the jumpring attached to the toggle clasp, the jumpring attached to the spacer bar and the loop on one end bar on one end of the bracelet, then close.

Pass an oval jumpring through the jumpring attached to the second half of the toggle clasp and the loop of the second end bar, then close.

: : : Additional Resources : : :

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

Have a question regarding this design idea? Email Customer Service.

Recommended Just for You