Multi-Strand Bracelet with Blue Sky Jasper Gemstone Beads, Antiqued Sterling Silver Beads and Crystal Passions® Beads

STEP 1
Cut four 10-inch lengths of Accu-Flex® professional-quality beading wire.
STEP 2
String onto one length of beading wire: one crimp, one Accu-Guard™ wire protector and one 10mm textured soldered jump ring. Pass the beading wire back through the crimp. Pull the beading wire so the crimp rests snug against the Accu-Guard leaving approximately 1/4 inch of beading wire on the end. Crimp then trim the excess from the short end of the beading wire. Finish with a crimp cover.

Inner Strands

STEP 3
String onto the length of beading wire:
  • Two sets of:
    • One 3mm bicone
    • One 5x3mm bumpy rondelle
    • One blue sky jasper 6mm round
    • One 5x3mm bumpy rondelle
  • Three 3mm bicones
  • Two sets of:
    • One 5x3mm bumpy rondelle
    • One blue sky jasper 6mm round
    • One 5x3mm bumpy rondelle
    • One 3mm bicone
STEP 4
String the corner of one 14mm spacer onto the beading wire then repeat Step 3 in the opposite direction.

Repeat Step 2 to secure the strand using the same jump ring.
STEP 5
Repeat Steps 2 - 4 using the opposite corner of the spacer.

Outer Strands

STEP 6
Repeat Step 2 with a new length of beading wire using the jump ring of one of the inner strands.
STEP 7
String onto the length of beading wire:
  • Two sets of:
    • One 3mm bicone
    • One 5x3mm bumpy rondelle
    • One blue sky jasper 6mm round
    • One 5x3mm bumpy rondelle
    • One 3mm bicone
    • One 5x3mm bumpy rondelle
    • One blue sky jasper 6mm round
    • One 5x3mm bump rondelle
    • Two 3mm bicones
  • Two 3mm bicones
STEP 8
Pass the beading wire through one of the unused corners of the 14mm spacer then repeat Step 7 in the opposite direction.

Repeat Step 2 using the jump ring on the opposite side to secure the strand.
STEP 9
Repeat Steps 6 - 8 using the last corner of the 14mm spacer.

Finishing the Bracelet

STEP 10
Pass one 6x4mm oval jump ring through one textured soldered jump ring then close. Repeat to create double jump rings.

Pass one 6x4mm oval jump ring through the previous two oval jump rings and one lobster claw clasp then close. Repeat to create double jump rings.

: : : Additional Resources : : :

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

Have a question regarding this design idea? Email Customer Service.