Cleaning a Clay ExtruderCB53
Once you are done using your extruder, it’s a good idea to make sure it is cleaned thoroughly before storing.
|Remove the bottom cap from the barrel.
Note: The disc may remain in the cap, if so, remove and clean any clay remaining on the disc.
Tip: If working with metal clay, save the clay you collect then add it to your fresh clay or use to make your own metal clay slip (paste).
|Remove the T-handle end from the barrel.|
||Note: The disc may remain on the clay on the plunger, remove the disc then clean any remaining clay from the surface. Remove any clay from the plunger.|
|Use a tool to remove the oh-ring from around the end of the plunger, then clean the ring and under and around where it rested.|
|Use a tool to clean the inside of the barrel.|
Have a question regarding this project? Email Customer Service.
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email firstname.lastname@example.org for more information.