Using Iced Enamels™

Instructions Courtesy of Susan Lenart Kazmer
F72H
STEP 1
Apply Medium to Copper Blank Lightly sand the surface of your metal bezel or silhouette with sandpaper.

Apply thin coat of Cold Enameling Medium to the surface.
STEP 2
Sprinkle Powder Over Medium Place metal to be enameled on a Teflon® sheet.

Sprinkle Iced Enamel Powders onto surface.

Gently shake off excess. (You should be able to put excess back into container.)
STEP 3
Heat Coated Blank Melt Iced Enamel Powders with craft heat gun. Work from the sides over to the top. When you see powder begin to bubble up but not pop, you know it is time to stop.

Tip: You can build up additional layers of enamels at this point.
STEP 4
Cool Then Apply Resin Let completely cool.

To seal, mix resin per manufacturer directions and apply a thin coat with disposable paint brush. Let dry 8 to 12 hours.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.