Close
Home
Beading Instructions

Beading Resources > Free Beading Instructions > > Protecting Tools with Tool Magic®

 Protecting Tools with Tool Magic® 

690N

Tool Magic is a wonderful product that makes your wire working less stressful! By coating your pliers with Tool Magic, you virtually eliminate making any tool marks when creating wire designs.


: : : Materials : : :
End of Materials List
Step 1
Open the jaws of the pliers to be protected.
Step 2
Dip the jaws of your pliers into the jar of Tool Magic just far enough in to cover most of the jaws.

Note: Do not dip the hinge of the pliers into the Tool Magic liquid.
Step 3
Pull the pliers out slowly, in an upward motion.
Step 4
Turn the pliers so that the jaws are pointing upward, then set them into a tool holder.
Step 5
Let the Tool Magic dry for 4 hours.

Note: It is best to let the Tool Magic dry undisturbed. Avoid air movement from wind or a fan; high heat; and humid conditions.
Step 6
Repeat to apply two more coats of Tool Magic.

Note: The Tool Magic will dry in 4 hours but it is recommended to let it cure for 24 hours for the best result.

Once the Tool Magic is cured, use the protected pliers for any wire-wrapping project.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists;
children 14 years of age or younger should use these products with adult direction.

Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA 97526-2373
Copyright 2008-2014 Fire Mountain Gems and Beads, Inc. All rights reserved.