How to Use The Bead Buddy® E-Z Looper™ Pliers

Instructions

Step 1

Insert the end of the wire below the peg in the center and through the notch of the cutting area on the right side of the pliers.

Tip: If the wire is too far back it will slip behind the jaws and not form a proper loop.

Step 2

While holding the bead or opposite end of the wire, squeeze the pliers to clip the excess wire and form the loop. Holding the bead or wire, bend the wire over the left jaw slightly to create a curve just above the loop.

Step 3

Remove the resulting loop from around the peg in the center of the pliers.

If needed, use a pair of chain-nose pliers to adjust the loop slightly to fully close it.

Shop for Your Materials Here:

Wire-Wrapping Wire No Category Name

Looper Pliers No Category Name

Wire-Wrapping Pliers No Category Name

Pliers No Category Name

Have a question regarding this project? Email Customer Service.

Copyright Permissions

All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.