Translate the determined size onto the appropriate spot on a bracelet mandrel (most bracelet mandrels are not marked by size like a ring mandrel) and tape a piece of Teflon® sheet at the spot while it dries. You could also look around your house for a suitable form, such as a large light bulb, plastic soda bottle or other large enough item.
Note: Aluminum is not a good form to use since there is a chemical reaction between the clay and the aluminum that will not translate well in firing--as in, your piece will be ruined.
Once the design is complete, determine if the bracelet can lay on its side. If so, can it lie flat on a kiln shelf or does it have too much detail and needs to rest on a fiber blanket or a bed of vermiculite?
Note: It is advisable to wear a dust mask when working with vermiculite.
Fill the opening of the bracelet with either a section of fiber blanket or dome the vermiculite inside the opening to help maintain the shape.
Note: It is advisable to wear a dust mask when pulling apart fiber blanket.
If the bracelet needs to remain vertical and you have a kiln with a large enough interior space, consider filling a kiln-proof (like an unglazed terra cotta pot) container with either fiber blanket or vermiculite and place the bracelet in accordingly so it is supported during firing.
- Tammy Honaman, Author, Jewelry-Making Expert and Educator
Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists; children 14 years of age or younger should use these products with adult direction.
Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA
Copyright 2008-2017 Fire Mountain Gems and Beads, Inc. All rights reserved.
Fire Mountain Gems and Beads reserves the right to make policy changes at any time without prior notice.