The first is to use a single temper of wire so that the coil of rings made for a particular project has similarly formed rings. A dead-soft tempered wire formed on a steel mandrel will give you a consistently wound coil from which to cut your rings.
The second factor is to use a good tool for cutting the rings. A jeweler's saw and saw blade will cut through the rings and leave a flush end on each wire end. Alternatively, a pair of good flush-cutters will also work. The better the tool the less the "pinch" you will have at the wire end of the jumpring. Another feature to consider is a sharp pointy tip on the flush-cutting pliers.
The third factor is to use two good tools to close the jumprings securely when assembling your chainmaille project. Flat-nose, chain-nose and bent-nose pliers all open and close jumprings nicely--choose two of your favorites.
In some cases, you may want to use a jumpring tool to open and close jumprings. View ''Using a Jumpring Tool'' how-to video and illustrated instructions to learn about this alternative to pliers.
- Sandra Lupo, Jewelry Designer and Instructor and Swarovski crystal Ambassador
Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists; children 14 years of age or younger should use these products with adult direction.
Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA
Copyright 2008-2017 Fire Mountain Gems and Beads, Inc. All rights reserved.
Fire Mountain Gems and Beads reserves the right to make policy changes at any time without prior notice.