Double-Strand Bracelet with Celestial Crystal® Beads

STEP 1
Cut two 10-inch lengths of Accu-Flex® professional-quality beading wire.
STEP 2
String onto one 10-inch length of beading wire: one crimp and one Accu-Guard™ wire protector. Pass the beading wire back through the crimp. Pull the beading wire so the crimp rests snug against the Accu-Guard leaving approximately 1/4 inch of beading wire on the end.

Insert the second length of beading wire into the crimp then crimp. Finish with a 3mm crimp cover.
STEP 3
String five translucent peacock AB half matte 8mm round beads, four translucent peacock AB half matte 10mm round beads and one translucent peacock AB half matte 12mm round bead onto both lengths of beading wire.

Separate the strands of beading wire.

First Strand

STEP 4
String the following onto one length of beading wire:
  • One 4mm smooth round
  • One translucent peacock AB half matte 8mm round bead
  • Two 4mm smooth rounds
  • First hole on one 11x2.5mm 2-strand spacer bar
  • Three 4mm smooth rounds
  • First hole on one 11x2.5mm 2-strand spacer bar
  • Two 4mm smooth rounds
  • Three translucent peacock AB half matte 8mm round bead
STEP 5
Continue to string one crimp and one Accu-Guard™ wire protector. Pass the beading wire back through the crimp. Pull the beading wire so the crimp rests snug against the Accu-Guard leaving approximately 1/4 inch of beading wire on the end.

Crimp, then trim the excess from the short end of the beading wire. Finish with a 3mm crimp cover.

Second Strand

STEP 6
String the following onto one length of beading wire:
  • One 4mm smooth round
  • One translucent peacock AB half matte 8mm round bead
  • Two 4mm smooth rounds
  • Second hole on one 11x2.5mm 2-strand spacer bar
  • One vitrail 38x38mm flower component
  • Second hole on one 11x2.5mm 2-strand spacer bar
  • Two 4mm smooth rounds
  • Three translucent peacock AB half matte 8mm round bead
Repeat Step 5 to secure the strand.
STEP 7
Pass one 4mm jumpring through the first Accu-Guard on the first strand and the top loop on the 2-loop side of one 12x5mm end bar then close.

Repeat to attach the Accu-Guards on the second strand to the bottom loop on the end bar.
STEP 8
Attach the loop on the 13x8mm lobster claw clasp to the 1-loop side of the 12x5mm end bar.

Attach one 5mm jumpring to the Accu-Guard on the opposite end of the bracelet.

: : : Additional Resources : : :

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

Have a question regarding this design idea? Email Customer Service.

Recommended Just for You