|Open a jumpring. Gently fold the two loops of the bail over the top edge of the donut, bending until the wires meet in the center of the donut.|
|Pass an open jumpring over one loop, through the hole of the donut, and around the other loop. Close the jumpring.|
|Cut a length of thread and knot the end of it. String on your beads, passing the thread through the jumpring in the center of the bail, but not through the donut. String your bead pattern in reverse, ending with a knot. Secure knot and trim the thread. Repeat until the donut hole is as full as you'd like it to be.|
Have a question regarding this project? Email Customer Service.
Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists; children 14 years of age or younger should use these products with adult direction.
Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA
Copyright 2008-2017 Fire Mountain Gems and Beads, Inc. All rights reserved.
Fire Mountain Gems and Beads reserves the right to make policy changes at any time without prior notice.