|After punching a hole in the leather, lay the washer or component over the hole and push the brad through both pieces.|
|While holding the brad and washer in place, turn the leather over and lay it on a metal block.
Add a flat washer to the brad then trim the brad with side-cutters to about 2mm above the flat washer.
|Using a ball peen hammer, hammer the brad flat against the washer securing the components in place.|
Have a question regarding this project? Email Customer Service.
Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists; children 14 years of age or younger should use these products with adult direction.
Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA
Copyright 2008-2017 Fire Mountain Gems and Beads, Inc. All rights reserved.
Fire Mountain Gems and Beads reserves the right to make policy changes at any time without prior notice.