|Rotate punch wheel until desired punch size is aligned with the lower jaw of the tool. Locking arm will snap into place when correctly aligned.|
|Insert a leather piece between the jaws of the punch tool at desired position. Be sure to have tool horizontally level to avoid punching hole at an angle.
Note: Laying a thinner scrap piece of leather between the strike plate and leather to be punched will result in a cleaner hole and help protect the strike plate keeping the tool sharp.
|Firmly squeeze handle grips until punch penetrates completely through the leather, then release the grips.|
Have a question regarding this project? Email Customer Service.
Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists; children 14 years of age or younger should use these products with adult direction.
Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA
Copyright 2008-2017 Fire Mountain Gems and Beads, Inc. All rights reserved.
Fire Mountain Gems and Beads reserves the right to make policy changes at any time without prior notice.