|Attach jumpring mandrel to hand-held power drill and thread wire through threader hole of desired jumpring size (7mm/5mm/3mm). Bend long end of wire back to secure.|
|Turn on power drill at slow speed to create desired coil length. Using flush-cutters, trim wire at threader hole then trim long end of wire at coil.|
|Remove coil from jumpring mandrel and cut coil into individual jumprings.|
Have a question regarding this project? Email Customer Service.
Products sold by Fire Mountain Gems and Beads® are intended for experienced jewelry-makers and designer-artists; children 14 years of age or younger should use these products with adult direction.
Fire Mountain Gems and Beads, Inc. - One Fire Mountain Way, Grants Pass, OR USA
Copyright 2008-2017 Fire Mountain Gems and Beads, Inc. All rights reserved.
Fire Mountain Gems and Beads reserves the right to make policy changes at any time without prior notice.