How to Use the Crystal Applicator™ Tool and 4-Piece Snap Die Set

Instructions Courtesy of Vendor
DA6U

Refer to Figure 1

STEP 1
Figure 1
Identify (A) upper and (B) lower die holders on tool.
STEP 2
Ensure tool handles can be closed completely. If necessary adjust with (C) stroke adjustment screw.

Refer to Figures 2 and 3

STEP 3
Figure 2

Figure 3
To apply front of snap to material, identify Front Die Set (SN001F) and attach upper and lower dies to die holders A and B on tool.
STEP 4
Insert Swarovski snap front components in appropriate Front Dies. This operation includes the decorative snap front. (To match correct dies and components, see details in Fig. 2)
STEP 5
Place material face down over lower die and squeeze handles, attaching stone to material. Release tool and gently pull material to remove from tool.
STEP 6
To apply back of snap to material, remove upper and lower dies and repeat Steps 3 - 4 with Back Die Set (SN001B) and snap back components.

IMPORTANT: For bracelet application, be sure material is face up when performing this operation.
STEP 7
Release tool and gently pull material to remove from tool. Front and back snaps are now applied.
STEP 8
Wear and enjoy!

: : : Additional Resources : : :


Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Recommended Just for You