Close
Home

How to Use the Crystal Applicator™ Tool and Button Die Sets

Instructions Courtesy of Vendor
DA6V

Refer to Figure 1

STEP 1
Figure 1
Identify (A) upper and (B) lower die holders on tool.
STEP 2
Ensure tool handles can be opened completely. If necessary, adjust with (C) stroke adjustment screw.
STEP 3
Pierce hole in material for button location as required. (If replacing existing buttons this will not be necessary.)

Refer to Figures 2

STEP 4
Figure 2
Place button in upper die with shank pointing downward.
STEP 5
Close the tool gently to ensure the button is positioned correctly in the upper die.
STEP 6
Place nail in lower die.
STEP 7
Position material over nail point.

When handling the material, be careful not to change location of the nail.

Button will not engage if the nail is not perfectly straight.
STEP 8
Squeeze handles until button and nail are securely attached to material. (This may require the use of both hands.)
STEP 9
Release the tool and remove button and material from upper die.

: : : Additional Resources : : :


Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.