Home

How to Use the Miracle Mount™ System

Presented by Rose, Jewelry Production Specialist, Marketing Content Development Group,
Instructions by Michelle Wood, Jewelry-Making Expert,
Exclusively for Fire Mountain Gems and Beads®
E61X

STEP 1
Apply 2-part epoxy around the inner edge of the back side of the Miracle Mount setting, then insert a Swarovski fancy stone embellishment into the center.

Place the edges of the back side of the setting between two small pieces of scrap clay to allow stone to lay flat while the epoxy cures.
STEP 2
Apply epoxy to the four holes on the back side of the setting. Place the four corresponding positioning posts, on the front side of the setting, into the holes.

Set the Miracle Mount aside to dry/cure for approximately 5-15 minutes.
STEP 3
Determine the desired hanging orientation for the pendant. Tip: It may be helpful to create a sketch of the desired orientation of the loop and tile pegs to use as a reference when gluing.

Place the setting on a piece of scrap clay so the edge is visible then glue the pegs into the slots along the edge in the desired pattern. Allow each side to dry before rotating the setting to the next set of slots along the edge.

Note: It is important to verifty the orientation of the round loop on each peg before placing the loop, square loop side, into the slot.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Recommended Just for You


Sign Up for Email Specials and Beading News
Sign Up
for Email Specials and Beading News