EUROTOOL® Beader's Delight Pliers

Presented by Esther Pollock, Lead Jewelry Designer, Marketing Content Development Group
Instructions by Rachel, Content Development Group, Exclusively for Fire Mountain Gems and Beads®
F539

Creating a Square Jumpring

STEP 1
Cut the desired number of lengths of wire.
STEP 2
Place one end of the length of wire in the groove located on the flat jaw on the Beader's Delight pliers. This allows you to create angles exactly the same distance apart.

Bend the wire over the edge of the jaw creating a 90-degree angle. Repeat to create a total of four angles, creating a square. Use the side-cutters to trim the end of the wire close to the finished square.

Creating a Wire Spiral

STEP 1
Cut the desired number of lengths of wire.
STEP 2
Place one end of the wire in the round-nose portion of the pliers. Rotate the pliers to form a loop on the end of the wire.
STEP 3
Place the loop between the flat jaws then pull the wire around the loop, rotating the resulting coil to the desired width. Use the round-nose portion of the pliers to form a loop on the end of the wire.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.

Recommended Just for You