Art Clay® Gold 22k

Instructions

As ART CLAY GOLD has different characteristic from original ART CLAY SILVER clay type, please read the directions and precautions before use.

Ingredients: 95% of indicated weight is K22 (Gold 91.7%, Silver 8.3 %). After firing: K22 100%

Firing Temperature/Holding Time:1814ºF for 60 min.

Melting Point:1931ºF

Preparation	Take out only the necessary amount of clay, wrap it in plastic wrap and knead it well. If it is stiff at first, warm it in your palm a little while. Place the unused portion of clay in a re-sealable bag and keep it in an air-tight container at room temperature to prevent it from drying up.
Molding	To join Art Clay Gold together or to mend a jointed area, use Art Clay Gold in paste form, which can be made as follows: Put Art Clay Gold in a small plate add a few drops of water and blend it evenly with something like a spatula Shape as you wish using your fingers, a mold, etc. If Art Clay Gold becomes stiff to handle, place it in a ziploc bag, add a few drops of water, and knead it until it becomes soft. Note: Remember that the finished piece shrinks 15%, so size your piece accordingly.
Drying
	Condition for Drying Dry the piece completely at room temperature (more than 24 hours) or by a hair dryer, etc.
	Hair Dryer	Approximately 10-15 minutes with 1200w hair dryer. Place the dryer within 6 inches from the piece.
	Hot Plate	Approximately 10 min. at 300-350ºF
	Electric Kiln	Approximately 10 minutes 300ºF
	Drying time is varies by size of the piece.How to Check If the Piece is Completely Dried Place the piece on a flat stainless, glass or plastic plate. After 10-20 seconds remove the piece. If there is no area of condensation left behind, it is completely dried.
Firing
	Place the piece in the kiln. (If you are firing more than two pieces, make sure the pieces are not touching each other)
	Temperature	1814ºF
	Holding Time	60 min.
	Take out the piece when the kiln temperature falls below 1112ºF.
Finishing	The surface of the fired piece will be matte, but luster can be obtained by polishing. ( e.g. stainless steel brush, burnisher, sandpaper, etc.)
Completing	After firing: K22 - 100%

Have a question regarding this tutorial? Email Customer Service.

Copyright Permissions

All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.

Art Clay® Gold 22k - Clay Type

Instructions

Copyright Permissions