Instructions
Cut a piece of Accu-Flex® Professional Quality Beading wire to the size needed for your beading project.
Pass the end of the Accu-Flex professional-quality beading wire through a crimp tube and through the tube on one side of the wire protector. You will notice that there is a tube on each end of the wire protector, with a channel in between.
Pass the Accu-Flex through the other tube then tighten. As you tighten, the Accu-Flex will lay flush in the channel.
Add one half of your clasp by sliding the loop up into the curve of the wire protector. Pass the Accu-Flex back through the crimp bead and crimp using crimping pliers. Using wire cutters, trim any excess Accu-Flex.
Note: Another option is to use a jump ring to attach each portion of the clasp. This may be necessary depending on the beads and clasp to be used in the design.
String your beads onto the Accu-Flex.
To finish, repeat Steps 2 and 3 using the other half of the clasp. Pull the Accu-Flex to make sure there is no slack along the length of the design. Crimp the bead to secure.
All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.
This website uses cookies and other tracking technologies to ensure you get the best experience on our website. By continuing to navigate this website, you consent to the use of these technologies for the purposes described in our Privacy Policy.