Design Idea 98UZ
-- Designer --
Tim Cronkhite, Exclusively for Fire Mountain Gems and Beads®
To learn more about Tim Cronkhite, read his jewelry artist success story here
: : : Materials : : :
Please take the creative opportunity to select the products of your choice for this design, offered here at Fire Mountain Gems and Beads.
Instructions
Using 1 of the head pins, string the crystals in the following order:
Place your round-nose pliers, horizontally, above the 6x6mm cube near the top of the head pin. Bend the head pin to a 90 degree angle. Turn the pliers so they are now vertical in the angled section.
Bring the tip of the head pin up and over the top barrel of the pliers so the wire is now facing downward.
Turn the pliers so they are horizontal again. Continue to bring the tip of the head pin around the barrel so the wire is now formed in a loop and the end is back out a 90 degree angle.
Remove the round-nose pliers. Grip across the loop with the chain-nose pliers. Grip the tip of the head pin with flat-nose pliers and wrap the head pin around the straight length of wire below the loop, making approximately three tightly wound wraps.
Using the side-cutting pliers, trim any excess wire, then press in the cut end with chain-nose pliers.
Using chain-nose pliers, slightly open the loop on an ear wire then slip on the wrapped loop. Close the loop on the snowman dangle.
Repeat Steps 1 - 5 to make the second earring.
Have a question regarding this project? Email Customer Service.
All works of authorship (articles, videos, tutorials and other creative works) are from the Fire Mountain Gems and Beads® Collection, and permission to copy is granted for non-commercial educational purposes only. All other reproduction requires written permission. For more information, please email copyrightpermission@firemtn.com.