Summer Holidays Key Pendant with Swarovski Crystal
Summer Holidays Key Pendant
-- Designer --
Courtesy of Swarovski
- Focal, Swarovski crystal, crystal silver shade, 33x24mm cosmic oval fancy stone
- Bead, Swarovski crystal, air blue opal, 8mm round
- Pearl, Swarovski crystal, platinum, 12mm round
- Beading needles
- Split rings
- Glues and adhesives
- Thread, Silkon, nylon
Nylon thread, transparent
Ribbon cotton, grey
Sewing thread, grey
Get inspired by Swarovski design team's limitless imagination. Magical project ideas bring a new dimension to simple techniques.
Cut 70 cm of ribbon. Fold it into half and then sew it with a sewing machine and iron it.
Start gluing the ribbon from one side of the Swarovski crystal Fancy Stone article 4137 33x24mm Crystal Silver Shade as shown in the illustration, hold in place with a clothespin. Cut any extra length of ribbon at the top as marked number 2 in the illustration.
Glue the ribbon onto the other half of the Swarovski crystal Fancy Stone and fix it again with the clothespin.
Cut 100 cm of 0.15 mm nylon thread. Sew the two layers of ribbon together with approximately 4 stitches.
Pull the ribbon tightly and wind it around the Swarovski crystal Fancy Stone three times. Sew all three layers of ribbon in exactly the same manner as done in the illustration to ensure that it's fixed properly around the stone.
Slide the Crystal Pearl article 5810 12mm (Crystal Platinum Pearl) onto the needle and thread and sew it in the middle of the charm. Pull the ribbon over this Crystal Pearl and fix it in place with the thread as shown in the illustrations.
Slide on the Swarovski crystal Bead article 5000 8mm Air Blue Opal onto the needle and thread and again pull the ribbon over this bead and fix it as depicted in the illustrations. Pull the ribbon over the Crystal Pearl (Crystal Platinum Pearl) and fix it as shown in the third picture in this step.
Slide the other Swarovski crystal Bead article 5000 8mm Air Blue Opal onto the needle and thread. Pull the ribbon over the Swarovski crystal Bead and fix it as shown in the pictures and then back over the Crystal Pearl and fix it here again.
Cut off any remaining ribbon. Fix it in between the bead and pearl and sew it over with 4 back stitches. Cut off thread.
Open the 18mm jumpring and hang it into the 30mm split ring and the charm as seen in the illustrations and close the jumpring.
: : : Additional Resources : : :
The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We
encourage you to substitute different colors, products and techniques to make the design your own.
Have a question regarding this design idea? Email Customer Service.