Ring with Swarovski Crystal
-- Designer --
Courtesy of Swarovski
- Bead, Swarovski crystal, jet, 2mm round (84 beads)
- Pliers, chain-nose
- Pliers, side-cutter
Bead, Swarovski crystal, light siam, 2mm round (60 beads)
Bead, Swarovski crystal, sapphire, 2mm round (40 beads)
Bead, Swarovski crystal, white alabaster, 2mm round (70 beads)
Sew-on component, Swarovski crystal, jet, 16mm (1 component)
Crimp bead, 2mm (8 crimp beads)
Jumpring, silver, 4mm (1 jumpring)
Wire, silver, 0.35mm
Wire, silver, 0.6mm
Wire, silver, 0.25mm
- Sew-on components, Swarovski crystal, rivoli flat back
- Beads, Swarovski crystal, 2mm round
- Crimp beads
Get inspired by Swarovski design team's limitless imagination. Magical project ideas bring a new dimension to simple techniques.
Cut a card board with scissor as in illustration. Cut 4x 30cm of the 0.35mm wire and 70cm of the 0.6mm wire. Wrap the 0.7mm wire around the 4 pieces of 0.35mm wire. Cut off 56mm of wire for ring size L. For M piece wire should be 52mm and for S 50mm.
Bend the wrapped part to form a ring and pull the 8 ends of 0.35mm wire through a 4mm jumpring as shown in illustration.
Bend the wire ends to form an even star as in illustration.
Bend wire on left side which is parallel to the ring through whole of CRYSTALLIZED™ sew-on stone article 3200 16mm jet and pull tight. Repeat this action with opposite wire and second whole of CRYSTALLIZED™ sew-on stone (see illustration).
Cut from 0.25mm wire with side cutter for A 12cm, for B 18cm, for C 20cm, for D 22cm, for E 26cm. Slide onto wire A, 28 CRYSTALLIZED™ beads article 5000 2mm white alabaster and go with one end a second time through all beads. Pull the ends tight to form a circle and wrap both ends twice around the ring (see illustration). Repeat this action with 40 CRYSTALLIZED™ beads article 5000 2mm sapphire for wire B, 44 CRYSTALLIZED™ beads article 5000 2mm jet for wire C, 52 CRYSTALLIZED™ beads 5000 2mm white alabaster for wire D and 60 CRYSTALLIZED™ beads article 5000 2mm light Siam for wire E.
Fix circle A with wires ends the same way as you did in Step 4. Where to fix it you see in illustration.
Repeat Step 6 with circle B.
Repeat Step 6 with circle C.
Repeat Step 6 with circle D.
Repeat Step 6 with circle E.
Slide onto each wire end CRYSTALLIZED™ beads article 5000 2mm jet and crimping tubes. For amount and sequence see illustration.
Pull the end of wire with 5 CRYSTALLIZED™ beads article 5000 2mm jet and one crimping tube through all beads of next wire.
Add one more CRYSTALLIZED™ bead article 5000 2mm jet on the longer wire and repeat Step 12 - 13 x6.
Cut all wire ends off with side-cutter and move beads so that ends are hidden.
Crimp all crimping beads with chain-nose pliers.
: : : Additional Resources : : :
The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We
encourage you to substitute different colors, products and techniques to make the design your own.
Have a question regarding this design idea? Email Customer Service.