Single-Strand Necklace and Earring Set with Swarovski Crystals®, Gunmetal-Plated Brass Charms and Components and Antiqued "Pewter" Beads

Necklace

STEP 1
Cut two 8-inch lengths of Almost Jewelry™ 3mm round and 7x4mm finished chain.

Tip: One of the lengths should include the provided clasp.
STEP 2
Mix Devcon® 5 Minute® Epoxy according to manufacturer's instructions.
STEP 3
Apply a small amount of epoxy to the setting on one 18mm round Almost Instant Jewelry® link and the back side of one ultra green AB 16mm rivoli.

Press the back side of the rivoli into the setting. Allow to dry.

Repeat to create a total of four ultra green links.
STEP 4
Repeat Step 2 then apply a small amount of epoxy to the setting on one 18mm round drop and the back side of one ultra green AB 16mm rivoli.

Press the back side of the rivoli into the setting. Allow to dry.

Repeat to create a total of two ultra green drops.

Repeat to create one ultra purple AB drop.
STEP 5
String one 8mm fancy flower component, one 24x24mm fancy flower charm and one 6x3mm cushion beaded rondelle onto one 9x5mm flower brad.

Trim the brad to about 2mm above the 6x3mm cushion rondelle then hammer the backside of the brad until flat.

Repeat to create a total of three flower links.

Necklace Assembly

STEP 6
Pass one 6mm jumpring through the first link on one length of chain and one loop on one ultra green link then close.
STEP 7
Pass one 6mm jumpring through the opposite loop on the ultra green link and one petal on one flower charm then close.

Repeat to connect a total of three sets of ultra green links and flower charms end-to-end then attach one ultra green link.

Continue to connect the loop on the opposite end of the last ultra green link to the first link on the remaining length of chain.
STEP 8
Using one 6mm jumpring, attach one ultra green drop to the bottom petal on one flower charm on one end of the necklace. Repeat to attach a second ultra green drop to the opposite end of the necklace.

Repeat to attach the ultra purple flower drop to the center flower charm.

Earrings

STEP 1
Mix Devcon 5 Minute Epoxy according to manufacturer's instructions.

Apply a small amount of epoxy to the setting on one 18mm round Almost Instant Jewelry® drop and the backside of one ultra green AB 16mm rivoli.

Press the backside of the rivoli into the setting. Allow to dry.

Repeat to create a total of two ultra green drops.
STEP 2
String one 8mm fancy flower component, one 24x24mm fancy flower charm and one 6x3mm cushion beaded rondelle onto one 9x5mm flower brad.

Trim the brad to about 2mm above the 6x3mm cushion rondelle then hammer the backside of the brad until flat.

Repeat to create a total of two flower links.
STEP 3
Pass one 6mm jumpring through the petal on one flower link and the loop on one ultra green drop then close.

Pass one 6mm jumpring through the loop on one earstud and the petal opposite to the previously used petal then close.

Repeat to create a second earring.

: : : Additional Resources : : :

The pieces featured in the Gallery of Designs are copyrighted designs and are provided for inspiration only. We encourage you to substitute different colors, products and techniques to make the design your own.

Have a question regarding this design idea? Email Customer Service.

Recommended Just for You